The Bell Stoker is the least expensive half-shell helmet in our test and shares the same retention system as Bell's more expensive Super. Our tests also found it to be well ventilated, lightweight, and very comfortable.
The Stoker received the second highest score in or ventilation test which make it a good choice for riding in hot temps.
The Stoker is one of the most comfortable helmets in our test. It tied the Giro Feature and Giro Xar with the second highest comfort score. The top score went to the Troy Lee A1, which fits like a glove and was the only lid to outscore these three other comfy options. We were a bit surprised to find the Stoker more comfortable than the Bell Super, which has more plentiful and slightly thicker padding. We feel that the Stoker is more comfortable because it is lighter and covers slightly less area of the head, which makes for less contact points.
The Stoker is padded in all the right places on the inside of the helmet to allow for all-day comfort. We especially like that the continuous brow pad does a better job than segmented pads of keeping sweat out of the eyes. The Speed Dial rear retention band is also well padded, which keeps it comfy even when the dial is cranked tight.
Luke Lydiard getting urban in the Stoker.
The Stoker shares the same Speed Dial Fit System as it's big brother the Bell Super. The retention system is one reason we like the Super so much, and it is equally awesome on the Stoker. This system consists of a semi-rigid rear retention band which is adjusted by a large dial covered in a rubbery material. We found this dial one of the easiest to operate especially, with full-finger gloves on. The chin strap is easily adjustable fore and aft via the same locking plastic hardware found on the Super as well. We prefer this type of locking yoke hardware because it keeps the straps in the same place ride after ride.
The Stoker (left) uses the same click wheel found on it's big brother the Bell Super (right).
Our scales measured our size medium Stoker at 11.7 ounces, which makes it the second lightest helmet by a small margin over the Giro Xar, which was the lightest at 11.3 ounces. The Giro Feature weighed in just 0.1 ounces heavier than the Stoker. The heaviest helmet we tested was the Bell Super, which weighs a noticeable 2.9 ounces more than the Stoker.
Weight weenies often compare dollar to weight savings. The Stoker is both inexpensive and light, which makes it one of the unusual products where you can spend less AND save weight. In the mountain bike world, products are usually either light or cheap, but not both. The Stoker is a rare case and that makes us, um, stoked.
The Stoker has just thirteen vents through it's shell, which isn't an impressive number compared to the 25 on the Super, but what we found in our test was that the number of vents has little to do with how well a helmet moves air around your head to keep you cool. The size and shape of the vents as well as the overall shape of the lid has a lot more to do with air movement than number of vents. The Stoker's vents are very large and do an impressive job of moving air in and out of the helmet to keep it cool. The Stoker scored the same as the Troy Lee A1, Giro Feature, and POC Trabec in our ventilation test. Only the Giro Xar outscored these helmets and only by a narrow margin.
The Stoker's padding is covered with Coolmax instead of the X Static found on the Super. Bell claims that the Coolmax keeps the head cooler while the X Static fights funk. We found that the Stoker is a much cooler helmet than the Super, but we feel that this is more due to the size and shape of the vents rather than the material the padding is covered in.
Top view of the Stoker showing its large but not very plentiful vents. Do you see the spooky face?
One area in which the Stoker lacks is in the size and adjustability of the visor. The visor is short and lacks the adjustment range of other helmets. The Stoker's stubby visor is attached at either side of the helmet by flat horizontal snaps that only allow for a small range of motion. These snaps are very similar to the visor snaps found on the POC Trabec, Giro Xar, and Fox Flux. We prefer visors that are attached by screws rather than snaps because they allow for more precise visor adjustments. If a secure, well-articulating visor is high on your list of important helmet qualities, then we recommend either the Bell Super or the Troy Lee A1. The Giro Feature also has a great visor with an excellent thumb screw to lock it in place.
The Stoker's visor is attached by flat snaps at either side of the visor. This system does not allow for as much fine tuning of visor position as other attachment methods.
Like the Super, the lower edge of this brain bucket's polystyrene foam is not completely covered by the polycarbonate shell. Instead Bell uses what they call Lower Strap Anchor Shell on the Stoker. This consists of two strips of shell material which protect the four strap yoke anchor points on either side of the helmet. This design will likely increase day-to-day durability slightly over helmets like the Giro Feature which has exposed and possibly vulnerable yoke anchor points. We would prefer that the shell wrapped completely around the bottom edge of the foam to protect it from dents and dings. The Troy Lee A1, Giro Xar, Fox Flux, and POC Trabec all have a full wrap shell to protect the foam when the helmet is off your head.
The Stoker meets the CE 1078 and CPSC Bicycle standards.
The Stoker uses Bell's Lower Strap Anchor Shell which consists of strips of polycarbonate to protect the polystyrene around the yoke anchor points. While this is better than nothing we prefer helmets with shell material which fully cover the bottom edge of the foam.
Protecting your head from rocks, dirt, and trees when riding on trails.
This is tied as the least expensive mountain bike helmet in our test and just narrowly missed winning our Best Buy Award. Instead this award went to the Giro Feature, which scored just slightly higher than the Stoker because it has a superior visor, similar to those found on much more expensive helmets like the A1 or Super. The Stoker's visor and visor attachment are so-so, and more akin to the attachments commonly found on cheaper helmets. Both the Feature and Stoker are excellent bargains. If you appreciate well articulating visors then go with the Feature. If visors aren't important to you, then the Stoker weighs just about the same and has a slightly better retention system for the same price.
The Stoker is an excellent extended coverage mountain bike helmet that gets a lot of trickle down engineering from its big brother, the Bell Super. It is one of the lightest, best ventilated, and most secure helmets we tested. Its major detractor is its visor, which is small and lacks a thumbscrew to adjust the amount of friction needed to move it or lock it in place. It is also the least expensive helmet in our test at $70, which we think makes it one of the best values on the market.